Rig it on the bow or the stern. Use a well secured pulley where the anchor drops off your boat. Scotty makes one, but there are lots of them available on sites like Bass Pro Shops, Cabelas, or West Marine.
Between the anchor pulley and your seat, run the line through something fairly large so that the line will not kink and prevent deployment or retrieval of the anchor. For mine, I attached padeyes, then ran a loop of line through the padeye, and a "quick link" to the line. This allows a kink or something to run through the quick link, but still keeps the line from going wherever it wants to run on the boat. At your seat, secure the line with a clam cleat or a jam cleat. A jam cleat is V shaped and you just mash the line down into it. Friction holds it. A clam cleat has to rotating cams that pinch the line to hold it. To undo the line you either just pull up on it or slightly back to rotate the cams. Each are very, very rapid ways to release line. This is important if your anchor binds up on something subsurface. If it does that and you can't release line, strong enough current will QUICKLY plane your boat to the bottom with you in it. DO NOT tie a knot in the end of the line to prevent it from slipping through the pulley. You WANT it to slip through the pulley as a safety factor. Finally, use enough line.
Those are my suggestions. As I said before, anchors on small boats can be hazardous. An eight pound anchor off of a kayak is not good. It would be better to buy a 2 lb coated dumbell and use it as the anchor. From a canoe, well then you start getting into some things about the size, the current, the depth, etc.
Just remember, when things go bad with an anchor, they go bad FAST. Be prepared for an emergency release, which should include cutting the line and losing the anchor. Keep the line controlled. Don't let it wrap around your ankles. Don't let it get kinked up. Just... be prepared. And EVERY MOMENT that you have the anchor deployed, be wearing your PFD even if you don't normally wear one.
- Big D
YakCatcher Rod Holder
Canoe Pack Liner
Bent Shaft Canoe Paddles
|Table of Contents|