My fin won't slide back
Posted by: sandy on Jun-15-14 6:53 PM (EST) Category: unassigned
Hi im brand new to SUP. I just bought a board and fin off of someone and I am trying to put the fin on the board. The board is a Tahoe Bliss and the fin is also a Tahoe fin. I can get the back part of the fin into the square wide opening but it will not slide back either direction into the channel. However if i turn the fin around so that its facing the wrong direction then it will slide either way into the channel. Obviously that won't work! I notice on the fin that the screw is much longer on one end than the other. Is this normal? Am i doing something wrong? Did i buy a defective board or a defective fin? Here is a picture of the back of the fin metal part thing:
Appreciate any help!
Sport Cases (Electronics)
Kayak & Canoe Outriggers
|Table of Contents|
|Messages in this Topic|
Try the SUP Board|
Posted by: grayhawk on Jun-15-14 8:40 PM (EST)
Posted by: sandy on Jun-15-14 8:43 PM (EST)
Gently tap it so it is centered ...|
Posted by: onnopaddle on Jun-15-14 10:28 PM (EST)
Lay on table / work bench so its not going to be moving around >>> with the pin just hanging off the edge ... then just tap with hammer ... A plastic one if you have it but no worries really.