-- Last Updated: Oct-15-13 12:54 PM EST --
Unless you are going to thread an end loop through a flotation tank, which Royalex canoes don't have, you can just drill your holes and run your rope or webbing through to the inside. Tie a figure-of-eight knot on each end. Or you can run a rope through both holes and tie a fisherman's knot on the hull exterior.
This is how it is done on virtually all whitewater Rx canoes and it works fine.
If you plan to use the end loops as carry handles, nylon webbing is a lot easier on the hands than rope, and works just as well to secure painters and tie downs.
Kindle / iPad Cases
Touring Kayak Paddles
Deck Rigging Gear
4-place Boat Trailer
Shirts / Tops
|Table of Contents|