Your #1 source for kayaking and canoeing information.               FREE Newsletter!
my Profile
 





 
Advice, Suggestions and General Help New Topic Printer Friendly Version

  From their website
  Posted by: ezwater on Apr-24-13 11:15 PM (EST)
 

"How hard is it to repair Trylon?
It’s not hard at all! There are many plastic welding adhesives that bond with Trylon for spot repairs, but we recommend the Devcon brand of waterproof bonds. You can use them around bulkheads and cockpit coamings in lieu of caulking or use the adhesive with pieces of ABS plastic for structural repairs."

They don't make the nature of Trilon clear to me, but it IS clear that epoxies will adhere to it.

Re-attaching a rim to a hull can be tricky. Personally, I might reinforce the repair with glass, but to get you back on the water, go get some Devcon or some thickened West G-flex, tape the rim in place on the inside/underside, position the hull so the epoxy doesn't tend to run off, and then use something like popsickle sticks to apply a bead of thickened epoxy to the outside/underside of the rim/hull joint. Don't use so much that it might interfere with whatever skirt you might be using.

Before you apply the epoxy, you should clean, sand, and clean again the surfaces where you will apply the epoxy. West recommends using a quick pass with a propane torch to flame and oxidize the plastic where the epoxy will be applied.

I haven't used Devcon in years. West G-flex hardens within an hour or two, but needs a day to reach full strength

 Great Products from the Buyers' Guide:

First Need Purifier

Sport Gloves

Heel and Pegpads™

ParkerMount

Kong Cable

Table of Contents
  • Repairing my boat - Lherz - Apr-24-13 9:08 PM
    • From their website - ezwater - Apr-24-13 11:15 PM

Google
 
Web Paddling.net


Follow us on:
Free Newsletter | About Us | Site Map | Advertising Info | Contact Us

©2014 Paddling.net Inc.
Sweepstakes Banjo Shirt