Your #1 source for kayaking and canoeing information.               FREE Newsletter!
my Profile
 





 
Advice, Suggestions and General Help New Topic Printer Friendly Version

  Dagger Alchemy rear hatch
  Posted by: acadia on Apr-07-13 4:27 PM (EST)
   Category: unassigned 

I love the boat, but I hate the rear hatch. Way too much water gets in during rolls and rescues. I've contacted my dealer a couple of times and he's working on a solution, but I wondered if anyone on this board has figured anything out. Thanks in advance!

 Great Products from the Buyers' Guide:

GO Trailer/Camper

GO Easy Utility Trailer

Kayalite

2-3 Canoe/Kayak Trailer

Table of Contents




Messages in this Topic

 

  I sealed the hatch holes up
  Posted by: trvlrerik on Apr-07-13 7:41 PM (EST)
I had minor a minor leaking issue with the rear hatch also (Alchemy S). I noticed that there were large spaces around the skeg control tube and there was also a hole at the top of the bulkhead that probably exists for pressure equalization issues.
Think of the problem this way; if you have a bottle with no holes and open the lid, water comes in slowly due to the pressure inside of the bottle. If the bottle has 2 holes water can enter rapidly as the pressure is allowed to leave via the secondary hole
I sealed around the skeg control with caulk and stuck a golf tee in the factory drilled pressure equalization hole. Leaks are no longer a major issue, not fully dry but not a major issue. (If I want to ensure a dry ride that is what I put in a dry bag).
I do not worry about losing a hatch lid due to pressure popping it off as it is under the straps in the J racks.

 
 
  Factory "kit"...
  Posted by: t.george on Apr-07-13 8:00 PM (EST)
Mine leaked terrible, the dealer ended up getting a "factiry retrofit kit", which amounted to a couple of 1/8" or so foam sheets that fit to the underside of the hatches to improve the seal. I glued them in so I wouldn't lose them. They don't cure the leaking, but lessened it considerably. I also found my bulkheads not to be fully sealed, used 3m 5200 "fast cure",(not the regular that takes 72hrs. to dry). Now the hatches stay only a lttle wet inside. One other thing for playing in the surf or rough water I did was to secure two lines to the perimeter lines that have a buckle at the center of the rear hatch, this creates an X over the hatch & now prevents it getting imploded or blown by a big wave & also helps the seal.

All the best, tOM
 
 
  Thanks
  Posted by: acadia on Apr-07-13 10:39 PM (EST)
I was thinking along the very same lines, so I'm glad to hear your solution is sort of working. And yes, I am as concerned about losing the hatch in rough water as I am about the leaking.

Shame. Such a lovely little boat. Kajaksport hatches would have been awesome...
 
 
  Contact Dagger
  Posted by: sternman on Apr-08-13 7:36 AM (EST)
Yes, call dagger and they will send you a new hatch with added foam seal. Otherwise I really love mine and have no other issues.
 

Google
 
Web Paddling.net


Follow us on:
Free Newsletter | About Us | Site Map | Advertising Info | Contact Us

©2014 Paddling.net Inc.
Sweepstakes Shirt Sale