Thank you everyone for your input!
I think I may go with Gnarlydog's idea - I remember not liking pad eyes very much when in a rescue class a few weeks ago.
In the short run - I may just forgo adding intermediate mounting points for the perimeter lines, if I can use the current bow/stern toggle points (will create another thread for this to help make this information easier to find for future kayakers in this situation)
Any tips when using epoxy resin? did you mix cut up fiberglass with it? Is there an optimal spacing you found when drilling the two holes - Almost considering removing my current pad eyes and drilling the pad eye holes a little larger to accommodate 1/4" rope - but think they may be too close together?
Thank you everyone again!,
Sport Cases (Electronics)
Recreational Kayak Paddle
|Table of Contents|